A Brake Controller is used to regulate a trailer’s electrical brake system. Linked to the power of the tow car as well as the electronic brake wires, the digital Brake Controller usually is positioned within arm’s reach of the driver. Electronic brake controllers will be adjusted to vary the ability of the electrical brakes when the brake pedal is utilized or be used to manually engage the brakes. Ford autos, able to towing trailers massive sufficient to need electrical brakes, are manufactured with a Brake Controller harness below the driver’s aspect dash.

Ford Brake Controller Installation Instructions

1. Look below the motive force’s dash. Pull free the white 4-pronged plug not related to anything. There could also be a rubber band securing a coil of wires to the plug. Allow the plug to hang at the full extension of the wiring.
2. Plug the brake controller’s Ford harness adapter into the white four pronged plug. The harness adapter will can help you connect the controller’s to the white 4-pronged plug. Plug the other finish of the harness into the controller’s.
3. Grasp the controller and place it on the location you plan to mount the controllers bracket. This lets you be certain the wires shall be of ample length for the supposed location. Sit within the driver’s seat and be certain the controller is within comfortable reach. Examine the meant location of the controller to make sure it doesn’t impede access to drive components, such because the parking brake, and will not impede the doorway and exit of the vehicle.
4. Mark the location of the mounting bracket. Screw the mounting bracket into the plastic dash. If crucial pre-drill slightly smaller holes.
5. Connect the controllers to the bracket. Tighten the retaining screws. Most controller brackets can help you swing the controller to be flush against the sprint when not in use. Tighten the screws all the way if you do not want to transfer the controller.
6. Connect the trailer plug to the vehicle’s tow plug. Connect the trailer. Have an assistant hearken to the trailer’s electric brakes as you depress the brake pedal. The brakes should connect and hum as the electrical current is applied. The brake controller should also provide a suggestions response. Brake controller response is usually shown in share energy applied or with a sign light.
7. Pull the trailer slowly as much as 20 miles per hour, then apply the brakes. Regulate the sensitivity of the brake controllers in response to your preference and producer guidelines.

Ford Brake Controller Installation Tips

Ford vehicles not originally outfitted with a towing package deal will need to have a trailer plug put in on the rear of the vehicle. Vans and SUVs will have the trailer wiring tucked up beneath the rear chassis of the car — close to the spare tire — or below the rear carpet of the back of the vehicle. Consult your proprietor’s manual for particular locations.